The strap-on Insert sensor consists of a stainless steel sheath temperature sensor, thermal conducting compound, and an adjustable pipe bracket accessory. The stainless steel sheath temperature sensor is suitable for direct application to pipe surfaces for chilled or hot water measurement.
The product is AC to DC switching power transfer device,of which the black pluggable connector fits onto most Temco products, or can be taken off to connect to your own devices.
This sensor is used to measure water temperature of heated or chilled water and other liquids in mechanical systems. The sensor is called an immersion type where the sensor is mounted in a brass or stainless steel thermowell which allows the probe to be removed from the pipe without draining the system and protects the probe.There are four thermistor based models, and one RTD version to provide compatibility with the majority of DDC systems.
Accurate Outdoor Air Temperature Sensor for HVAC systems with a sealed stainless steel probe, PVC radiation shield, 2m cable, and quick-response thermal grease.
This sensor is used to measure the supply and return temperature in HVAC system. The flange mount design makes it easy to install the sensor in tight quarters. There are several sensor elements to choose from which guarantee compatibility with all popular DDC systems. The probe in the photo is our standard model which is always in stock, it has a 8″ probe and a 120″ cable, and employs either a precision thermistor or platinum film sensor, so field calibration is not required. The 10ft(3m) cable is “Plenum Rated”.
The AO2DO module converts T3 controller analog outputs into reliable dry contact relay signals. With a simple snap-on design, it delivers quick, wiring-free installation and dependable performance for automation needs.
The Actuator is intended for ON-OFF and floating point controls in HVAC systems. It can easily mount on a 1/2″ round or square shaft with solid screw sets. Angle of rotation is mechanically limited to 90 degree. When the actuator reaches its maximum position, the device will automatically stop. An override lever is provided on the side to manually disengage the gear. Two mechanical stops are provided for extra adjustments.
The MY2N Relay is a general purpose plug in relay with a LED for power switching applications,built-in diode and surge suppression, test push buttons and more.MY2 = 2-Pole; MY4 = 4-Pole; N = LED; Z = Bifurcated; I = Push-to-Test.
Thermostat cover is designed to prevent adjustment of the temperature by unauthorized personnel.
The MR Mechanical Relay is a general purpose relay suitable for both low voltage and power switching. It features a low power coil, the 12VDC version requires only 100ma to energize. The DPDT relay is rated at 10A, 120VAC. Each relay has an LED showing the low voltage status.
English 
Chinese 