T3-OEM Bacnet programmable controller
- September 15, 2020
- 0 Comment(s)
The T3 -OEM Bacnet programmable controller is a low cost performer with big system features.
T3E-6CT
- March 8, 2018
- 0 Comment(s)
The T3E-6CT is general purpose input / ouput modules for building integrators, providing convenient termination for field devices and interfacing to your HVAC, lighting, temperature sensors, and other typical building automation applications.
T3E-Nano Programmable Router
- July 31, 2025
- 0 Comment(s)
The new ESP32-POE board is an ESP32-based development board with built-in PoE (Power over Ethernet) and standard Wi-Fi support
Tamper Proof room temperature sensor
- May 17, 2016
- 0 Comment(s)
The tamper proof room temperature sensor with Torx security screws designed for use with building automation systems in commercial buildings, hospitals, museums or other facilities requiring accurate measurement of room temperature. This sensor can be directly mounted to drywall or an 11-10 electrical handy box.
Tank Level Sensor
- June 26, 2019
- 0 Comment(s)
SUS 316 Stainless stell ,Standard SAE 5 hole pattern ,Output signal:0-10k ohm.
Temperature and Humidity Transducer With Bacnet and Modbus
- July 6, 2021
- 0 Comment(s)
Temperature and Humidity Trasnsmitter with Bacnet/Modbus over RS485,0-10v 4-20ma output signals. Sensor is overmolded into a pluggable, waterproof connector
Temperature Transducer with Bacnet and Modbus RS485
- December 17, 2019
- 0 Comment(s)
Duct mount temperature only transducer, Bacnet/Modbus over RS485, 0-10v 4-20ma output signal
Terminal Shorting Bar
- May 17, 2016
- 0 Comment(s)
Terminal shorting bar,10 pin.Use these strips to run a common conductor through multiple terminals on any of the Temco T3 series controllers and I/O modules. The outer bar is covered in high temperature ABS. They’re available in 10 pin only version for now, you can cut them down for shorter runs or gang them up for longer runs.
Thermostat cover
- May 17, 2016
- 0 Comment(s)
Thermostat cover is designed to prevent adjustment of the temperature by unauthorized personnel.
Thermowells
- May 17, 2016
- 0 Comment(s)
These thermowells are designed for mounting temperature sensors in pipes and tanks.The thermowells are designed to handle this stress while providing good thermal contact with the fluid.They also provide isolation, if the sensor needs to be serviced the system can remain in operation without having to drain the lines. The thermowells are machined from a single piece of bar stock, there are no welds as found on competing products.