This Probe Temperature Sensor comes standard with a 15mm Stainless Steel Temperature Sensor. This sensor is a 10K Thermistor, with an industry standard Type 2 curve.Connected to the end of the Sensor is 2 UL2468 26/2CAWG 105°C Black Wires with tinned ends.
The 330mv AC series of split core current sensors are ideal for installation on existing electrical wiring by snapping around the conductor without requiring and rewiring or interruption of the existing power cabling. UL listed product.The current flowing through the core of this CT produces an output signal from 0 to 330mv ac, proportional to the current. The signal is a low voltage mv ac signal which needs signal conditioning before going into the typical controller.The 330mvac signal is compatible with our T3-6CT and the Wattnode power meter on this site.
The Pitot Tube is a differential pressure producer suitable for air flow measurement.It includes multiple sensing points to measure total and static pressures. It is easy to install and cost effective. It offers simple, low cost installation into pipes and ducts, and high energy savings due to its low unrecovered pressure loss. There are no moving parts or sharp edges to wear, so long term accuracy can be maintained. It contains a lid,connector and two 1 meter length pipes.All Extrusion pipe could be cut on site with a hacksaw,no need a special tool.For example:Buy a 12″ long pipe,and cut to 8″,buy 1m long pipe and cut to the length needed.
The Pressure Monitor is used to measure differential pressure in the range of +/-1″ wc full scale, +/-8″ wc, 0 ~100 PSI,0~250 PSI.It combines precision, high sensitivity silicon sensing capabilities and the latest ASIC technology to substantially reduce offset errors due to changes in temperature, stability to warm up, long term instability and position sensitivity. BACnet MS/TP and Modbus RTU protocols over RS485,with an ethernet port.
The sensor measures temperature in stratified air such as the mixing sections of air handlers. The sensor has a standard 10k type 2 temperature-resistance curve compatible with all major control systems.
The LRSSR Solid State Relay brings solid state reliability to control systems in HVAC and light industrial duty applications.
PSN40-400A differential pressure switch is used for fan status and dirty filter applications. A knob with pressure values on it allows the setpoint to be adjusted visually in the field. The plastic duct probe tubes, flexible silicon tubing and the mounting screws are included with all models.
HPB5 series are suitable to industrial control circuit with AC 50Hz or 60HZ, 0~380V rated voltage and 0~220V D C operating voltage,used for the control of magnetic starter, contactor, relay and other electric circuit.
The water flow sensor is mainly composed of a plastic valve body, a water flow rotor assembly and a Hall sensor, which is installed in the water inlet end of the water heater for detecting the water flow, when the …
Omron General-Purpose Relay available in SPDT and DPDT with either AC or DC coils. It comes with a pluggable base for easy din rail mounting and fast swapping of relays in the field. The narrow width allows for high density i/o in controls cabinets. The LED indicator on the low voltage coil provides handy indication of the relay status.All of the prices below are for the relay with LED option and the din rail base included.